Setting a router and 2 switches into a network

Post a reply


In an effort to prevent automatic submissions, we require that you complete the following challenge.
Smilies
:D :) ;) :( :o :shock: :? 8-) :lol: :x :P :oops: :cry: :evil: :twisted: :roll: :!: :?: :idea: :arrow: :| :mrgreen: :geek: :ugeek:

BBCode is ON
[img] is ON
[flash] is OFF
[url] is ON
Smilies are ON

Topic review
   

Expand view Topic review: Setting a router and 2 switches into a network

Re:Setting a router and 2 switches into a network

by Guest » Wed Sep 06, 2006 2:24 am

  ip route 0.0.0.0 0.0.0.0 192.168.100.100 Reffering to this command - tell me please what does it mean this IP: 0.0.0.0 0.0.0.0And what about my providers DNS, Have I indicate it somwere?

Re:Setting a router and 2 switches into a network

by Guest » Wed Sep 06, 2006 1:50 am

1. You need configure a default router on 2811 router to point to the default gateway.     ip route 0.0.0.0 0.0.0.0 192.168.100.1002. If you don have dhcp server in your internal network, you can configure 2811 router as a dhcp server as well. It will assign IP, gateway, dns to PC.you can refer to the following link to configure DHCP server on IOS router.http://www.cisco.com/en/US/docs/ios/12_ ... syip2.html

Re:Setting a router and 2 switches into a network

by Guest » Wed Sep 06, 2006 1:48 am

1 )okay, I see.. so there is the next situation: eth 0/1 > 192.168.100.200eth 0/2> 10.10.0.1 The network (192.168.100.0 has the access to internet through the gateway - 192.168.100.100 (the server) and its DNS are: 195.22.225.11; 195.22.225.34    ) So, on the router  I add this interfaces:eth 0/1 > 192.168.100.200 eth 0/2> 10.10.0.1 what after that? how to add the dns servers? and I have to show this ip 192.168.100.100 somewhare? so please write how it should look like, in real conditions Im usnig CISCO 2800 series router.

Re:Setting a router and 2 switches into a network

by Guest » Wed Sep 06, 2006 1:26 am

In your diagram, you only have one router and both subnet is directly connected to this router. Therefore, you don need any routing configuration here. Routing protocol such as RIP is used to tell the other router in your network about routing information.For example, in the following topology, you need run routing protocol on all three routers so that Router1 could learn the route to 23.23.23.0/24 and 3.3.3.0/24 which are not directly connected to it. (1.1.1.0/24)--Router1--(12.12.12.0/24)----Router2----(23.23.23.0/24)-----Router3----(3.3.3.0/24)

Re:Setting a router and 2 switches into a network

by Guest » Wed Sep 06, 2006 12:45 am

Yeah, thats the matter.. the default gateway, it helped me a lot! thx! stupid mistake, what about the entire configuration it is resonable? I mean correct? or there is a more rational way to implement?

Top