User Policies in SA540

Post a reply


In an effort to prevent automatic submissions, we require that you complete the following challenge.
Smilies
:D :) ;) :( :o :shock: :? 8-) :lol: :x :P :oops: :cry: :evil: :twisted: :roll: :!: :?: :idea: :arrow: :| :mrgreen: :geek: :ugeek:

BBCode is ON
[img] is ON
[flash] is OFF
[url] is ON
Smilies are ON

Topic review
   

Expand view Topic review: User Policies in SA540

Re:User Policies in SA540

by Guest » Fri May 07, 2010 2:32 pm

5.5.0.1 is what you should put in.  Techinically, it should be 5.5.0.0, but it looks like there is some data verification that isn correct.

Re:User Policies in SA540

by Guest » Fri May 07, 2010 12:52 pm

So using my last example. In the IP network field I would put 5.5.1.1  and in the mask I would put 16?  or would it be 5.5.0.0 and 16 for the mask?

Re:User Policies in SA540

by Guest » Fri May 07, 2010 12:02 pm

In that case, it would be 16. Each octet is 8 bits.  It would be a 16 bit mask since you want to cover 2 octets. 255.0.0.0 = 8255.255.0.0 = 16255.255.255.0 = 24

Re:User Policies in SA540

by Guest » Fri May 07, 2010 11:51 am

Any chance you could go into more detail. When I change the option to IP Network it still only has room for a single IP address but it also allows me to change the Mask Length.  Sadly Im not sure what Mask Length means. Lets say I want to limit access to only IP addresses in the range of 5.5.1.1 to 5.5.255.255.  What would I put in the Network Address/IP Address field and what value would the Mask Length be?

Re:User Policies in SA540

by Guest » Fri May 07, 2010 10:42 am

If you change the option to network, it will allow you to put in a subnet.

Top