ipv6, dhcp with a standalone server

VTP, Portfast, Spanning Tree and all the other switch related stuff.
Post Reply
Guest

ipv6, dhcp with a standalone server

Post by Guest » Sat Jul 05, 2008 3:43 am

Hello everyone ! Im trying to set up a small network with one cisco 3750G. Ive got 3 VLANs, two for client subnets and one for my windows 2008 r2 dhcp server. I want to use my windows server as the dedicated dhcp server. I have assign ipv6 addresses to all my vlans and tried to enable ipv6, ipv6 unicast-routing and relay agents but i can get any leases from my dhcp server to my clients. Has anyone got a clue on how to solve this ? //MrJanolov, Sweden

Guest

Re:ipv6, dhcp with a standalone server

Post by Guest » Sat Jul 05, 2008 4:27 am

Hi, You want your clients to get ipv6 config via DHCP and not the addresses via SLAAC? if so then you can suppress RA on the interface pointing towards client with the ipv6 nd suppress-ra command or use the ipv6 nd managed-config command to tell the clients to use DHCPv6 and not SLAAC. Regards.  Alain.

Guest

Re:ipv6, dhcp with a standalone server

Post by Guest » Sat Jul 05, 2008 5:40 am

yes exactly.Okey Ill try to supress the RA, will be back with the results. Thnx for your answer. //MrJanolov

Guest

Re:ipv6, dhcp with a standalone server

Post by Guest » Sat Jul 05, 2008 6:04 am

Hello again! It worked when I added both commands under the client VLANs. Thnx again. //MrJanolov

online cialis

hello guos 9128738514

Post by online cialis » Tue Jan 05, 2021 4:02 pm

hello guos 9128738516

Post Reply