half duplex or full duplex configuration for MDS9124 management port?

Support for NAS servers.
Guest

half duplex or full duplex configuration for MDS9124 management port?

Post by Guest » Tue Aug 11, 2009 5:00 am

Hi All, Is it possible to set the management port of mds 9124 about half or full duplex configuration? I want to correct following error: Jun 13 10:27:20.799 GMT: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on GigabitEthernet4/18 not half duplex, with mtw1pc02bs0(FOX1450G8QG) mgmt0 (half duplex). it seems mds 9124 set his port to half duplex. Dennis

Guest

Re:half duplex or full duplex configuration for MDS9124 management port?

Post by Guest » Tue Aug 11, 2009 6:00 am

You may want to check this thread : https://supportforums.cisco.com/thread/2059109 Else try the following : switch# config terminalswitch(config)#switch(config)# interface mgmt0switch(config-if)# switchport duplex full switch(config)# exitswitch#switch# copy running-config startup-config  Also, I would suggest you check what the counterpart of your MDS switch mgmt interface is set to (i.e. is it set to autoneg, then try setting it to fix speed/duplex or the other way around).

Guest

Re:half duplex or full duplex configuration for MDS9124 management port?

Post by Guest » Tue Aug 11, 2009 6:49 am

Hi Dennis, You might have hit bug CSCte76880 (http://tools.cisco.com/Support/BugToolK ... CSCte76880) Configure both interfaces to auto duplex achieve a full duplex connection as a workaround, or upgrade to 4.2(7e) or 5.0(4d) where the fix has been integrated. Best Regards,Vincent

Guest

Re:half duplex or full duplex configuration for MDS9124 management port?

Post by Guest » Tue Aug 11, 2009 8:22 am

Hi Dennis, is there a reason you
e not using auto detect?

Guest

Re:half duplex or full duplex configuration for MDS9124 management port?

Post by Guest » Tue Aug 11, 2009 9:20 am

Hi Kris, Becasue network admin told me that he got the error message:Jun 13 10:27:20.799 GMT: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on GigabitEthernet4/18 (not half duplex), with mtw1pc02bs0(FOX1450G8QG) mgmt0 (half duplex). Best Regards,Dennis

Post Reply