Can WAP200E repeat with other AP models?

Linksys, Netgear, ect. Webbase configurations for Wireless access points.
Guest

Can WAP200E repeat with other AP models?

Post by Guest » Sat Jan 22, 2005 8:10 am

Hi guys, Can WAP200E repeat with other AP models? I think it should be working with other models as the signal should be the same in different APs. Is that correct ? Regards,Henry

Guest

Re:Can WAP200E repeat with other AP models?

Post by Guest » Sat Jan 22, 2005 8:20 am

Sir, Thank you for visiting Cisco Community Forum. Note: For the AP Client and Wireless Bridge Modes, the remote access point must be a second Linksys Wireless-G Access Point. For the Wireless Repeater mode, the remote wireless bridge must be a second Linksys Wireless-G Access Point or Wireless-G Router. The WAP200E uses WDS (http://en.wikipedia.org/wiki/Wireless_D ... ion_System) - WDS may be incompatible between different products (even occasionally from the same vendor) as it is not certified by the Wi-Fi Alliance http://www.cisco.com/en/US/products/ps1 ... 8f1f.shtml It may be possible to bridge different models if they also use WDS where you can match up the MAC addresses on both sides. Thanks,Jeff.

Guest

Re:Can WAP200E repeat with other AP models?

Post by Guest » Sat Jan 22, 2005 8:27 am

Thanks Jeff. Appreciated...

Post Reply