QOS for Serial Interface in IOS-XR

Static, RIP, EIGRP, OSPF, BGP, IBGP, IS-IS and any other routing.
Guest

QOS for Serial Interface in IOS-XR

Post by Guest » Fri Sep 15, 2006 5:33 am

Hi, I am trying to configure QOS for a FR serial interface in IOS-XR.But I don see an option for configuring input/output service-policy in IOS-XR 3.9.1  for serial interface. These options are available for ethernet subinterfaces.. Following is the config:!class-map match-any QOS2 match dscp af21 af22 af23 match precedence 2 end-class-map!class-map match-any QOS3 match dscp af31 af32 match precedence 3 end-class-map!policy-map QOS_MAP  class QOS3  set dscp af21 ! class QOS2  set dscp af21 ! class class-default  set dscp default ! end-policy-map!RP/0/8/CPU0:TEST-IOS-XRconfig#interface gigabitEthernet 0/1/0/4.1416RP/0/8/CPU0:TEST-IOS-XR(config-subif)#service-policy ?  input   configure a policy in the input direction  output  direction of service policy application  type    Enter service policy type (default: qos) RP/0/8/CPU0:TEST-IOS-XR(config-subif)#exitRP/0/8/CPU0:TEST-IOS-XR(config)#interface serial 0/0/1/0/1/1.500RP/0/8/CPU0:TEST-IOS-XR(config-subif)#service-policy ?  type  Enter service policy type (default: qos)RP/0/8/CPU0:TEST-IOS-XR(config-subif)#service-policy type ?                                        ^% Invalid input detected at ^ marker.!!interface Serial0/0/1/0/1/1.500 point-to-point cdp vrf TEST ipv4 address 10.10.10.1 255.255.255.252 pvc 500! Has anyone experienced this issue? Thanks,

Guest

Re:QOS for Serial Interface in IOS-XR

Post by Guest » Fri Sep 15, 2006 5:37 am

Hi Kokul, You must be in pvc mode to configure service-policy on this interface RegardsMahesh

Guest

Re:QOS for Serial Interface in IOS-XR

Post by Guest » Fri Sep 15, 2006 7:04 am

Thanks Mahesh. It works..I didn check this option earlier.. Thanks,Kokul

Post Reply