TE Over a directly connected link

Static, RIP, EIGRP, OSPF, BGP, IBGP, IS-IS and any other routing.
Guest

TE Over a directly connected link

Post by Guest » Fri Oct 19, 2007 5:23 am

I am trying to build a TE over a directly connected link ofcourse between loopbacks for Fast RR purposes. will it work ? doesnt seem to be coming up ...

Guest

Re:TE Over a directly connected link

Post by Guest » Fri Oct 19, 2007 6:43 am

rajivrajan1 wrote: I am trying to build a TE over a directly connected link ( ofcourse between loopbacks) for Fast RR purposes. will it work ? doesnt seem to be coming up ... Can you provide configurations of both devices? Atif

Guest

Re:TE Over a directly connected link

Post by Guest » Fri Oct 19, 2007 7:53 am

Thank for reply. A-B-C on a triange - A-C via B is UP .. A to C directly connected TE is not coming up. All i wanted to know is is there any restriction to build a TE between two directly connected routers ?  I am assuming it may be due to lebel pop .. not sure .. just wanted to confirm..

Guest

Re:TE Over a directly connected link

Post by Guest » Fri Oct 19, 2007 8:08 am

Hi, Can you post the output of following commands: show mpls traffic-eng tunnels show mpls traffic-eng tunnels brief  show ip rsvp interface show run int "Tunnel Interfaces" show mpls traffic-eng topology brief

Guest

Re:TE Over a directly connected link

Post by Guest » Fri Oct 19, 2007 9:36 am

here you go

Post Reply