voice on 2801 with vic3-2fxs/did

Cisco CallManager, Cisco CallManager Express and IP Video
Guest

voice on 2801 with vic3-2fxs/did

Post by Guest » Thu Nov 05, 2009 5:40 pm

hi,I am trying to configure voice on 2801 with vic3-2fxs/did while IOS is 12.420Tdail tone is available but when i dial number dail tone is still cont...no ring tone  voice-port 0/0/0 input gain 7 cptone BR timeouts call-disconnect 5 timeouts wait-release 5!voice-port 0/0/1 input gain 7 cptone BR timeouts call-disconnect 5 timeouts wait-release 5!dial-peer voice 410 pots destination-pattern 410 port 0/0/0!dial-peer voice 411 pots destination-pattern 411 port 0/0/1! *****same configuration worked for me using vic2-2fxs with IOS 12.4(15)T or etc.,, now cisco replaced vic2-2fxs with vic3-2fxs/did and it will work only on IOS 12.4(15)ZX or 12.4(20)T. after upgrading IOS router can  see the voice card and i configured ports ..dail tone there but when dailing on number dail tone is not changing to ring tone.. pls advise.. Thanks

Guest

Re:voice on 2801 with vic3-2fxs/did

Post by Guest » Thu Nov 05, 2009 6:06 pm

That should be all you need to get this to work.  Collect:debug voip ccapi inoutdebug vpm sig And for kicks, try it with input gain at 0.

Guest

Re:voice on 2801 with vic3-2fxs/did

Post by Guest » Thu Nov 05, 2009 6:11 pm

Hi Steven,Thanks for your support man..Input gain 0 worked.. thanks again.regards,

Post Reply