switchport setup for lwapp access point running several ssids

Configuring Wireless Cisco Networks and Wireless Controllers.
Post Reply
Guest

switchport setup for lwapp access point running several ssids

Post by Guest » Sat Dec 25, 2010 4:20 am

Hi all

when setting up an lwapp acces point, do I need to trunk all the vlans on the port to the ap? or do I only need to enable the management vlan to the acces point ? ie 1 vlan and normal access port ?

 

cheers

 

Carl


Guest

Re:switchport setup for lwapp access point running several ssids

Post by Guest » Sat Dec 25, 2010 4:46 am

If its a LWAPP AP, then the switchport should be a ACCESS PORT.. this is just to get the IP address to the AP, then the AP wil try to join the WLC.. once the AP joins, the SSID and rest flow through the LWAPP tunnel..

 

Regards

Surendra


Guest

Re:switchport setup for lwapp access point running several ssids

Post by Guest » Sat Dec 25, 2010 6:24 am

Unless you are doing HREAP with more then 1 SSID. Then it would be a trunk ...


Post Reply