Firewalls, PIX, ASA, VPN, Access Control List, User Authentication, Data Encryption and Best Practices.
1 post • Page 1 of 1
I need to get the SN info and hardware info from my standby ASA remotely. Is there a way to do it? I tried to SSH to the standby using the standby IP address, and I can connect. I was able to do that with the PIX 535. I also tried via the ADSM and can connect, and logged into the Active Primary and issued various commands but it only gives info on the Active.
Hi, Try this, When you are connected to Active box and want to run command on standby use following failover exec standby <command>, for ex: failover exec standby sh ver Command reference: http://www.cisco.com/en/US/docs/securit ... #wp1929296 I hope this will help. -Shahid