6500 - IOS Upgrade

This is for more general topics about networking and vendors.
Guest

6500 - IOS Upgrade

Post by Guest » Sun Jan 09, 2011 3:10 pm

Hi, 6506 is running CAT OS and I need to upgrade the software to IOS. On CAT OS the switching module and routing module are on different session.  My question1 After upgrade wil I get single session to manage switching & routing module(2) on CATOS we got LACP configured ; is any modification needed on it(3) Any Change in configuration is needed for Two SUP Anything else to watch out before the upgrade. ThanksST

Guest

Re:6500 - IOS Upgrade

Post by Guest » Sun Jan 09, 2011 3:23 pm

Hello Saquib, you need to follow the procedure for CatOS to IOS conversion you need to do it two times one for each supervisor /MSFC so your first step is to remove one sup convert  the remaining sup, then you will remove the converted supervisor and you will insert the other one alone and you will perform conversion again for the second supervisor.At the end you will insert first sup again and you should be able to get one active and the other standby in native mode at the end you will get a single session to access the device (2) on  CATOS we got LACP configured ; is any modification needed on it LACP is supported on IOS too but you need to configure it. By the way the device needs to be configured.There is a config conversion tool but it is not recommended. http://www.cisco.com/en/US/products/hw/ ... bfa6.shtml follow the document step by step depending on your sup model HW and SW requirements are listed it will take some time (hours) Hope to helpGiuseppe

Guest

Re:6500 - IOS Upgrade

Post by Guest » Sun Jan 09, 2011 4:58 pm

Giuseppe Thanks You are alwayz a great help :-) I will follow as you recommended. Ganesh thanks as well.

Guest

Re:6500 - IOS Upgrade

Post by Guest » Sun Jan 09, 2011 5:49 pm

<div class="

Post Reply