Ive set up a UC520 with Call Connector for Dynamics CRM and am having a few teething problems.
Ive got it installed, the searching an dialing from the system menu is working fine. The problems Ive got firstly is that there is no Dial button appearing on any of the CRM forms. ISV Integrations are enabled, there just doesn seem to be any changes made during installation. I have run the installer again.
Secondly I am having trouble getting the phones to lookup from the CRM database. This is mostly due to my lack of knowledge of setting up an IP Phone Lookup Service, if you could point me in the direction of some documentation Id be grateful.