Is packet tracer 5.1 or 5.2 enough to simulate all labs of CCNP exams?

This is for more general topics about networking and vendors.
Guest

Is packet tracer 5.1 or 5.2 enough to simulate all labs of CCNP exams?

Post by Guest » Sat Dec 25, 2010 4:20 am

Now am practicing for BSCI and BCMSN.I don`t have any facility to do labs. 1  Is packet tracer 5.1 or 5.2 enough to simulate all labs of CCNP exams..?          And i could find layer 2 switchs in packet tracer 5.1. 2) ip helper-address will support in layer 2 switches..?

Guest

Re:Is packet tracer 5.1 or 5.2 enough to simulate all labs of CCNP exams?

Post by Guest » Sat Dec 25, 2010 5:46 am

Now am practicing for BSCI and BCMSN.I don`t have any facility to do labs. 1)  Is packet tracer 5.1 or 5.2 enough to simulate all labs of CCNP exams..?      And i could find layer 2 switchs in packet tracer 5.1. 2) ip helper-address will support in layer 2 switches..?Hi, Packet tracer 5.1 is good for practising labs for CCNP routing or switching and also you can try GNS3 for real time simulation of labs for CCNP and for your second question  L2 switch supports VLANs, but cannot route traffic from one VLAN to another without help from another L3 device to do the routing. You will need to configure a trunk port to whatever device you use for routing, and configure the ip helper-address on each subinterface or vlan interface you setup on the L3 device. Hope to Help !! Ganesh.H Remember to rate the helpful post

Guest

Re:Is packet tracer 5.1 or 5.2 enough to simulate all labs of CCNP exams?

Post by Guest » Sat Dec 25, 2010 6:19 am

Thank you Ganesh.H,I installed GNS3,but it is asking to register with atleat one ios.so how we wil do that...?


Post Reply